Home Skip to main content

MPC Research Reports
Filter by University

45 report(s) found for Utah State University
1 - 10 of 45 1 2 3 4 5 Next Page
   

Autonomous vehicles (AVs) that utilize LiDAR (Light Detection and Ranging) and other sensing technologies are becoming more prevalent in the transportation industry. Concurrently, transportation agencies are increasingly challenged with asset management, traffic operations, and safety assessments. The...

 

The use of deicing salts on highway bridges has decreased the service life of bridge decks due to the accelerated corrosion of the steel reinforcement. The use of Glass Fiber Reinforced Polymer (GFRP) in bridge decks as a means of corrosion-mitigation has been met with some success; however, GFRP is...

 

Calcium sulfoaluminate (CSA) cement was used to cast a prestressed voided deck slab bridge girder. The rapid-set properties of CSA cement allowed the initial concrete strength to reach the required 4300 psi needed in order to cut the prestressing strands 6.5 hours after casting. Prestress losses were...

 

When a vehicle drives over a bridge, each bridge girder carries a portion of the vehicle's weight. This load causes strain in the bottom of the bridge girders. However, depending on where the vehicle is located on the bridge, some bridge girders carry a higher percentage of the vehicle's load. This study...

 

Highway project selection and scheduling are traditionally treated as two separate problems in the literature. It is critical to investigate how to select and schedule M&R projects in a way that can maximize their benefit or effectiveness while minimizing the traffic impacts of work zones across project...

 

Battery electric buses with zero tailpipe emissions have great potential to improve environmental sustainability and livability of urban areas. However, the problems of high cost and limited range associated with on-board batteries have substantially limited popularity of battery electric buses. The...

 

As the population grows and travel demands increase, alternative interchange designs have become increasingly popular. The diverging diamond interchange is an alternative design that has been implemented in the United States. This design can accommodate higher and unbalanced flow and improve safety at...

 

Highway assets, including traffic signs, traffic signals, light poles, and guardrails, are important components of transportation networks. They guide, warn, and protect drivers and regulate traffic. To manage and maintain the regular operation of the highway system, state departments of transportation...

 

For this research, sensors were used to investigate the differences in prestress losses and temperature gradients in a concrete deck bulb tee girder bridge. The Millville Bridge was built as an access point to the Ridgeline High School in Millville, Utah. The bridge was built in 2016 and presently supports...

 

Redundancy is vital for transportation networks to provide utility to users during disastrous events. In this project, we develop two network-based measures for systematically characterizing the redundancy of transportation networks: travel alternative diversity and network spare capacity. The travel...

 
1 2 3 4 5 Next Page
NDSU Dept 2880P.O. Box 6050Fargo, ND 58108-6050
(701)231-7767ndsu.ugpti@ndsu.edu