Home Skip to main content

MPC Research Reports
Filter by Keyword

22 report(s) found with laboratory tests in the keywords field
1 - 10 of 22 1 2 3 Next Page
   

This report describes the research efforts aimed at determining the repeatability of the IDEAL-CT test for use as part of the balanced asphalt mix design process. Three mixes in common production in northern Utah were investigated by three different labs experienced in performance testing. Within-lab...

 

An evaluation of CRCP was conducted in order to determine the extent of possible corrosion of CRCP on selected interstates in South Dakota. General observations showed there were sections of severe and localized reinforcement corrosion at some crack locations. Crack mapping, chloride tests profiles...

 

The Rocky Mountain Region has experienced considerable difficulty because of alkali-silica reaction (ASR) in concrete construction. Wyoming Department of Transportation was successful in using recycled concrete aggregate (RCA) on Interstate I-80 with limited ASR damage. Reusing concrete from demolition...

 

Longitudinal joints in Portland Cement Concrete (PCC) pavement slabs require tie (dowel) bars to control joint opening resulting from thermal stresses. Inspections of PCC pavements by the South Dakota Department of Transportation using ground penetrating radar revealed that it is common for tie bars...

 

To improve the pavement design and construction in Wyoming, the Wyoming Department of Transportation (WYDOT) is adopting the Mechanistic-Empirical Pavement Design Guide (MEPDG). A full implementation of MEPDG requires the characterization of local crushed base materials. In this research, laboratory...

 

Many laboratory studies have shown erratic flexural strength results among replicate specimens of fiber reinforced concrete (FRC). As a result, repeatability of results was very challenging. Given this issue, it would be very difficult for design engineers to make reliable claims about the performance...

 

Concrete infrastructures in cold areas such as South Dakota tend to experience early deterioration that is mostly triggered by steel corrosion. The corrosion is initiated by chloride penetration through cracks in the concrete. Fiber reinforced concrete (FRC) is known to be a good alternative to conventional...

 

Over the years, Fiber Reinforced Polymer (FRP) composites have gained popularity in transportation infrastructure as a material able to restore and increase the capacity of existing concrete elements. Properties such as a high strength to weight ratio, non-corrosive nature, durability, and high malleability...

 

This study presents the results of the most recent phase of laboratory research. The effects of support movements observed in the field test were examined by physical laboratory testing and computer-based structural modeling using AxisVM software [Inter-CAD. Kft, 2004]. The goal of this research was...

 

This research evaluates the effectiveness of hot-poured crack surfacing material and its ability to seal asphaltic cracks. The term "crack surfacing" is used to describe the rigidity of the material and to distinguish it from crack sealants. The University of Wyoming, in cooperation with the Wyoming...

 
1 2 3 Next Page
NDSU Dept 2880P.O. Box 6050Fargo, ND 58108-6050
(701)231-7767ndsu.ugpti@ndsu.edu