|
|
Research Reports
Filter by Keyword10 report(s) found with beams in the keywords field 1 - 10 of 10 This report presents the feasibility of a novel anchor system that mitigates the end-peeling of carbon fiber reinforced polymer (CFRP) sheets used for strengthening reinforced concrete beams. Contrary to conventional anchoring methods, CFRP sheets are embedded inside the pre-grooved concrete and covered... The use of Carbon Fiber Reinforced Polymers (CFRP) for the repair of civil infrastructure has been on the rise. Most studies have focused on the effect of CFRP to increase the stiffness and strength of reinforced concrete beams or columns. Limited attention has been given to the effect of CFRP on mitigating... This report presents a two-phase research program studying i) galvanic current influencing deterioration of carbon fiber reinforced polymer (CFRP) sheets bonded to a steel substrate and ii) electrochemical reaction for steel beams strengthened with CFRP. The first phase of the research presents an experimental... This report presents an initial investigation of the mechanics of I-beams developed with plastic-aluminum composite technology. Plastic-aluminum composites in structural beam/frame/truss elements are a relatively new concept that has seen little, if any, application in modern construction. This technology... The motivation for this report is a proposed new microelectromechanical systems (MEMS) sensor with applications in civil infrastructure sensing. This report analyzed the influence of three assumptions employed in the Euler-Bernoulli, Rayleigh, and Timoshenko beam theories by comparing their results to... This report describes research performed in coordination with work at the University of Stuttgart, attempting to establish the S-N curve for fatigue loading of notched wood-concrete connections based on low/high-cycle, repeated loading tests. Experimental results are obtained on fourteen 1524 mm span... This research study focused on the long-term and repeated load behavior of wood-concrete composite beams in which the wood layer is composed of recycled utility poles. Previous research studies have found this type of a beam to have high efficiency and to be a potentially viable replacement for short... Research at Colorado State University in wood-concrete layered composites for structural applications has been in progress for more than a decade. Key features of the research are experimental and analytical work to analyze notched shear key interlayer connections. These connections are being used to... The concept of combining wood and concrete in layered composite bridge deck was investigated. A shear key/anchor detail recently used in Europe to construct floors in office buildings was adapted for this study. This connection detail provides the interlayer shear transfer between the layers. Laboratory... This project included two laboratory studies and analytical work dealing with T-beams comprised of a concrete flange connected to a wood beam plus plywood sheathing. Based on the experimental results of tests of 72 slip specimens and 4 full-scale layered T-beams, the mechanical behavior of different... |
