|
MPC Research Reports Filter by Keyword9 report(s) found with mix design in the keywords field 1 - 9 of 9 In recent years, major initiatives have been taken to replace non-renewable materials with environmentally friendly and sustainable ones. The present study was undertaken to apply a scalable process for laboratory production of cellulose nanofibers (CNF) and to evaluate the feasibility of using the produced... Ultra-high-performance concrete (UHPC) is distinguished by its superior mechanical and durability properties. These characteristics are attained through a precise mixture design that includes a low water-to-cement ratio, high fineness supplementary cementitious materials (SCMs), and steel fibers. This... An evaluation of the ability of the BBR (Bending Beam Rheometer) as a test to determine changes in the low temperature properties of asphalt mixture parameters was conducted, along with the possible implications of adopting this test for low temperature pavement performance. It was found that the creep... Many laboratory studies have shown erratic flexural strength results among replicate specimens of fiber reinforced concrete (FRC). As a result, repeatability of results was very challenging. Given this issue, it would be very difficult for design engineers to make reliable claims about the performance... An experimental research study was conducted to develop optimized concrete mixtures for jointed plain concrete (JPC) pavements and field evaluation of newly constructed JPC pavement sections along South Dakota highways.
Using South Dakota aggregates, different concrete mixtures were assessed for optimum... Concrete infrastructures in cold areas such as South Dakota tend to experience early deterioration that is mostly triggered by steel corrosion. The corrosion is initiated by chloride penetration through cracks in the concrete. Fiber reinforced concrete (FRC) is known to be a good alternative to conventional... The ultimate objective of this project was to develop widely accepted recommendations on self-consolidating concrete (SCC) mixture design for its use in WisDOT bridge projects. This project investigated the effects of material constituents on the material properties of trial SCC mixtures made from precasters... This research focuses on the beneficial utilization of Spray Dryer Ash (SDA) and investigates its performance in concrete for structural and transportation applications. Based on the challenges associated with disposal of all coal ashes, and SDA in particular, and the economic and environmental costs... In this study, the researchers evaluated the performance of asphalt mixes prepared using the Marshall mix design method and the Superpave level one mix design method. The Georgia Loaded Wheel Tester and the Thermal Stress Restrained Specimen Tester were used to test the rut-resistance and low-temperature...
|