|
MPC Research Reports Filter by Keyword42 report(s) found with evaluation in the keywords field Gravel road safety is a crucial area of road safety since gravel roads represent a substantial proportion of the entire nation's roadway network. Also, gravel roads pose inherent hazards that are otherwise absent in paved roads. Nonetheless, research related to assessing road conditions for county gravel... Fourteen Thin Lift Treatments (TLTs) in Utah's Department of Transportation (UDOT) Region 2 were evaluated over a five-year period in order to assess their performance. Surface distress data was quantified using Pavement Condition Indices (PCIs), and Remaining Service Life (RSL) were estimated following... The Congestion Mitigation and Air Quality Improvement (CMAQ) program was implemented to provide funding to transportation projects that contribute to air quality improvements. Wyoming has used these funds for a number of years to apply dust suppressants to unpaved roads around the state. Many of these... This study is part of a multiple year study conducted at the University of Wyoming to assess the effectiveness of dust suppressant treatments on gravel roads. The multiple year study was conducted to assist the Wyoming Department of Transportation and the Federal Highway Administration optimize the use... The State of Wyoming road network is characterized by heavy truck traffic. In 2015, truck traffic was approximately 22% of vehicle miles traveled (VMTs) along all routes in Wyoming, according to the WYDOT Annual Traffic Report. The heaviest truck traffic exists along I-80 with about 47% truck VMTs. Trucks... As the population grows and travel demands increase, alternative interchange designs have become increasingly popular. The diverging diamond interchange is an alternative design that has been implemented in the United States. This design can accommodate higher and unbalanced flow and improve safety at... The First Mile Last Mile (FMLM) challenge garners significant attention as a means to assess the accessibility of the first leg to transit and the last leg from public transit. As a critical barrier to public transit accessibility, the challenge provides many opportunities to closely analyze conditions... Perception-reaction times (PRT) and deceleration rates are critical components in the design of highways and streets. This research has several objectives, including 1) evaluate differences in PRT and deceleration rates between crash and near-crash events, 2) assess the correlation between PRT and deceleration... Roadside barriers are the primary structural safety devices on surface roads. They can be made from any material as long as they can absorb the energy involved in an impact scenario. One material that has that potential is Ipe, which is a hardwood material that has relatively high strength compared with... A research study was conducted by South Dakota State University in cooperation with the South Dakota Department of Transportation (SDDOT) to assess applicability of the American Association of State Highway and Transportation Officials (AASHTO) design calculations for the dynamic ice loads on bridge...
|