Home Skip to main content

Research Reports
Filter by Keyword

4 report(s) found with stresses in the keywords field
1 - 4 of 4
 

Field samples were obtained from cores taken from multiple roads around the Salt Lake Valley in Utah and prepared for BBR testing. The response of field cores showed that even though the same binder grade used in the region was the same, the resulting mixtures have significant differences in creep moduli...

 

Current pavement design based on the AASHTO Design Guide uses an empirical approach from the results of the AASHO Road Test conducted in 1958. To address some of the limitations of the original design guide, AASHTO developed a new guide: Mechanistic Empirical Pavement Design Guide (MEPDG). This guide...

 

This report is Phase II of a previous MPC research project (MPC 02-136) that developed a computer model using a transient, two-dimensional finite volume approach to mathematically describe the thermal response of asphalt pavements due to thermal environmental conditions on an hourly basis. The main objective...

 

This research evaluates the effectiveness of hot-poured crack surfacing material and its ability to seal asphaltic cracks. The term "crack surfacing" is used to describe the rigidity of the material and to distinguish it from crack sealants. The University of Wyoming, in cooperation with the Wyoming...

 
NDSU Dept 2880P.O. Box 6050Fargo, ND 58108-6050
(701)231-7767ndsu.ugpti@ndsu.edu