|
|
MPC Research Reports
Filter by Keyword71 report(s) found with tests in the keywords field Soils are an important component of any transportation structure. To improve the engineering properties of these soils, compaction requirements are included in virtually all transportation construction specifications. Field observations indicate however, that soils at near-freezing temperatures may require... The feasibility of using the Georgia Loaded-Wheel Tester (GLWT) to predict rutting in the laboratory was investigated in this research. This research was performed in two phases. The first phase consisted of modifying the GLWT to handle 15.2 cm (6 in) cores, developing a laboratory compaction procedure... The objectives of this projects were to: 1) develop a load test facility which can be used to perform static lateral load tests on model piles, 2) establish a prototype pile and a corresponding model pile, 3) design and implement the instrumentation for the model pile, 4) calibrate the model piles, 5)... This paper presents results of laboratory tests conducted to determine the effects of additives on the stabilization of unpaved road surfaces. Laboratory tests can be an efficient means of determining which additive will best stabilize a given unpaved road surface, but correlation between laboratory... This report describes a study jointly conducted by the University of Wyoming and the Wyoming Department of Transportation to better understand how selecting an Mr value influences the thickness of an asphalt overlay pavement. The objectives of this study were to: 1) investigate the importance of several... In this research the feasibility of using the Georgia Loaded-Wheel Tester (GLWT) to predict rutting in the laboratory was investigated. The study consisted of modifying the GLWT to handle 15.2 cm (6-in.) cores, obtaining asphalt pavement cores from several test sites throughout Wyoming, collecting rut... This report is an interim report for the first phase of an ongoing project entitled "Moderate Weight Bridge Guardrail for Rural Sites." The objective is to examine the potential of a new bridge guardrail concept as a means of increasing the safety of travel over rural bridges. This project is conducted... A research study was conducted to investigate the potential application of Intelligent Vehicle/Highway Systems (IVHS) technologies for reducing accidents on rural roads. After studying existing technologies, their present application to transportation, and approaches to identifying predominant accident... This report describes a study jointly conducted by the University of Wyoming and the Wyoming Department of Transportation to examine the factors influencing the determination of a subgrade resilient modulus value. The objectives of this study were to first, investigate the importance of several fundamental... This project included two laboratory studies and analytical work dealing with T-beams comprised of a concrete flange connected to a wood beam plus plywood sheathing. Based on the experimental results of tests of 72 slip specimens and 4 full-scale layered T-beams, the mechanical behavior of different... |
