|
MPC Research Reports Filter by Keyword8 report(s) found with stiffness in the keywords field 1 - 8 of 8 Reinforced concrete bridge wall piers constructed using older codes perform inadequately during strong earthquakes; deficiencies include short reinforcement lap splices, insufficient steel reinforcement ratios in the longitudinal and transverse direction, and inadequate seismic detailing. Three half-scale... Precast prestressed double-tee girders are common on county bridges in South Dakota because of the ease of construction, short construction time, and low cost. However, the longitudinal joints of these bridges are rapidly deteriorating, imposing girder replacement after only 45 years of service. Currently... This report details the outcomes of shear spiking two open-deck, timber trestle railroad bridges and examining the effectiveness under applied loading. The bridges were made available to the researchers by the Union Pacific Railroad and were located in their Southern Region. The first site was located... The use of off-specification fly ashes to increase the shear strength and stiffness of an expansive soil-rubber (ESR) mixture is investigated systematically in this study. The off-specification fly ashes used include a high-sulfur content and a high-carbon content fly ash. A class C fly ash is used as... This research evaluates the effectiveness of hot-poured crack surfacing material and its ability to seal asphaltic cracks. The term "crack surfacing" is used to describe the rigidity of the material and to distinguish it from crack sealants. The University of Wyoming, in cooperation with the Wyoming... Investigations into the effects of the addition of vertically-oriented shear spikes with fiberglass reinforced polymer rods have shown that the shear spikes increased the effective stiffness of the stringers of a full-scale timber bridge chord specimen. This was previously found to be true on dimension... Investigations into the effects Z-spiking with fiber reinforced polymer (FRP) rods have on the flexural stiffness and repair of deteriorated railroad crossties were conducted. These tests were conducted to provide a pilot study for an ultimate goal of repairing full-scale bridges. This report presents... The present research suggests a new approach to the use of composite materials technology for repair of timber structural members. Due to the small aspect ratio of the typical railroad bridge span timbers, stiffness degradation can be related to decrease in the beam's shear performance. To rejuvenate...
|