|
|
MPC Research Reports
Filter by Keyword47 report(s) found with performance in the keywords field Current pavement design based on the AASHTO Design Guide uses an empirical approach from the results of the AASHO Road Test conducted in 1958. To address some of the limitations of the original design guide, AASHTO developed a new guide: Mechanistic Empirical Pavement Design Guide (MEPDG). This guide... The use of self-consolidating concrete (SCC) for the manufacture of precast structural elements provides the benefits of increased rate of production, reduced labor needs (safety), and enhanced product quality. The same benefits apply to cast-in-place construction, especially with closely spaced reinforcing... As more Recycled Asphalt Pavement (RAP) becomes available to use in roadways, The Wyoming T2/LTAP Center and two Wyoming Counties investigated the use of RAP in gravel roads. The Wyoming DOT and the Mountain-Plains Consortium funded this study. The investigation explored the use RAP as a means of dust... Recent studies have shown that the use of self-consolidating concrete (SCC) results in improved finished quality, increased production efficiency, and reduced labor cost. Because of the favorable properties that SCC exhibits, the Federal Highway Administration and the precast concrete industry have been... High Performance Steel (HPS) is a superior material with higher yield strength, improved weldability, greater levels of toughness, and improved weathering resistance that can lead to more economical bridges than conventional steel bridge designs. AASHTO Load and Resistance Factor Design (LRFD) provisions... Coal ash is the portion of ash rejected by the stack and collected at the base as a waste product. Coal ash is comprised of bottom ash and fly ash. Fly ash accounts for 70 percent to 80 percent of total coal ash and the rest being bottom ash. Only 39 percent of bottom ash is utilized with the rest being... A testing facility for temporary longitudinal barriers was constructed at Colorado State University's Engineering Research Center which allows manufacturer's the opportunity to test their safety barriers prior to full-scale federal testing. This facility enables manufacturers to subject their products... This study reports on the performance of the extended HOV lines. Vehicle volume, average vehicle occupancy (AVO), modal split, person throughput, and violation rate were collected manually. Travel time and speed data were collected using the floating car method and global positioning system (GPS) software.... This paper reports on a two-year study evaluating HOV lane performance. The analysis assesses the freeway operations before the HOV lanes opened with continued assessment throughout the first year of operation. It looks at automatic data from traffic monitoring stations and manual data from roadside... The main objective of this study was to investigate the effect of the addition of a coal combustion remnant called bottom ash into asphalt mixes. The intent was to determine if mixes prepared with bottom ash showed degradation of desirable performance measures when compared to control mixes. This was... |
