|
|
Research Reports
Filter by Keyword30 report(s) found with methodology in the keywords field This report describes methods that allow for assessing structural integrity using a direct porting of imaging methods captured by both hand-held and uncrewed aircraft system (UAS)-assisted photography into computational analysis tools to monitor structural degradation of transportation structures. Of... A theoretical framework is developed for applying the material point method (MPM) to problems of modeling natural hazard effects on several representative geometries. Following an outline of the general methodology, in which the structural system is replaced by a combination of integrated Lagrangian... When designing transportation infrastructure, stormflow hydrographs are commonly estimated using synthetic unit hydrograph (UH) methods, particularly for ungauged basins. Current synthetic UHs either consider very limited aspects of basin geometry or require explicit representation of the basin flow... Tribal communities recognize the need to improve roadway safety. A five-step methodology has been developed by the Wyoming Technology Transfer Center (WYT2/LTAP) to improve roadway safety on reservations. This methodology was initially implemented on the Wind River Indian Reservation (WRIR), which led... Tribal communities recognize the need to improve roadway safety. A five-step methodology has been developed by the Wyoming Technology Transfer Center (WYT2/LTAP) to improve roadway safety on Indian reservations. This methodology was initially implemented on the Wind River Indian Reservation (WRIR), which... Tribal communities recognize the need to improve roadway safety. A five-step methodology has been developed by the Wyoming Technology Transfer Center (WYT2/LTAP) to improve roadway safety on reservations. This methodology was initially implemented on the Wind River Indian Reservation (WRIR), which led... Due to the current limitations on seismic forecasting, there is a high chance that a considerable number of vehicles would remain on a bridge when an earthquake occurs. In traditional seismic analyses, traffic loads were often ignored. Existing mode-based bridge-traffic interaction analysis usually cannot... Long-span bridges support a large amount of traffic every day. Even when an earthquake strikes, a long-span bridge often still has many vehicles present due to the low predictability of earthquake events. To study the seismic performance of bridge and traffic systems, a new full-response prediction methodology... The most common type of bridge on South Dakota local roads is a precast prestressed double-tee (DT) girder bridge. More than 700 DT bridges are currently in-service in South Dakota. Structural detailing, aging, traffic volume, and environmental conditions affect structural performance, integrity, and... The roadside area where fixed-object hazards are explicitly minimized is called the clear zone, which became standard design practice soon after the 1966 Congressional hearings on road and automobile safety. Mounting evidence, however, is beginning to cast doubt on what we think we know about the impact... |
