|
MPC Research Reports Filter by Keyword10 report(s) found with girders in the keywords field 1 - 10 of 10 According to the 2017 ASCE Infrastructure Report Card (ASCE 2017), 9.1% of the U.S. bridges are structurally deficient. The majority of deficient bridges are in service on low-traffic volume roads, and these bridges should be replaced or repaired for public safety in a timely manner. As an alternative... Calcium sulfoaluminate (CSA) cement was used to cast a prestressed voided deck slab bridge girder. The rapid-set properties of CSA cement allowed the initial concrete strength to reach the required 4300 psi needed in order to cut the prestressing strands 6.5 hours after casting. Prestress losses were... This report presents a research program studying the grooved bonding schemes of composite sheets (carbon fiber reinforced polymer, CFRP) for rehabilitating concrete members. The first phase of the research presents the efficacy of functional periodicity on controlling the occurrence of interfacial failure... When a vehicle drives over a bridge, each bridge girder carries a portion of the vehicle's weight. This load causes strain in the bottom of the bridge girders. However, depending on where the vehicle is located on the bridge, some bridge girders carry a higher percentage of the vehicle's load. This study... The South Dakota Department of Transportation (SDDOT) allows the use of precast double-tee bridges in counties because they are economical and fast in construction. Alternative durable prefabricated bridge systems are needed to provide more options to local governments. The present study was carried... Precast/prestressed double tee bridge girders are widely used for accelerated bridge construction on local roads in South Dakota. A common issue among existing double tee bridges in South Dakota is the rapid deterioration of longitudinal joints (shear keyways) between adjacent girders. Deteriorated joints... This report presents a two-phase research program studying i) galvanic current influencing deterioration of carbon fiber reinforced polymer (CFRP) sheets bonded to a steel substrate and ii) electrochemical reaction for steel beams strengthened with CFRP. The first phase of the research presents an experimental... This research focuses on finding a method for creating cost effective and innovative steel bridges in Colorado. The design method that was discovered to create this cost efficiency was designing the beams as simply supported for non-composite dead loads, beam weight and wet concrete, and then making... Recent studies have shown that the use of self-consolidating concrete (SCC) results in improved finished quality, increased production efficiency, and reduced labor cost. Because of the favorable properties that SCC exhibits, the Federal Highway Administration and the precast concrete industry have been... A project to study the pier moment-rotation behavior of compact and non-compact high performance steel HPS70W bridge I-girders was conducted at Colorado State University in the context of examining two restrictions for inelastic design of steel bridge girders in the current edition of the AASHTO LRFD...
|