|
MPC Research Reports Filter by Keyword22 report(s) found with asphalt pavements in the keywords field As more Recycled Asphalt Pavement (RAP) becomes available to use in roadways, The Wyoming T2/LTAP Center and two Wyoming Counties investigated the use of RAP in gravel roads. The Wyoming DOT and the Mountain-Plains Consortium funded this study. The investigation explored the use RAP as a means of dust... This report is Phase II of a previous MPC research project (MPC 02-136) that developed a computer model using a transient, two-dimensional finite volume approach to mathematically describe the thermal response of asphalt pavements due to thermal environmental conditions on an hourly basis. The main objective... This research evaluates the effectiveness of hot-poured crack surfacing material and its ability to seal asphaltic cracks. The term "crack surfacing" is used to describe the rigidity of the material and to distinguish it from crack sealants. The University of Wyoming, in cooperation with the Wyoming... Coal ash is the portion of ash rejected by the stack and collected at the base as a waste product. Coal ash is comprised of bottom ash and fly ash. Fly ash accounts for 70 percent to 80 percent of total coal ash and the rest being bottom ash. Only 39 percent of bottom ash is utilized with the rest being... In this study, the researchers evaluated the effectiveness of quality control/quality assurance (QC/QA) specifications in decreasing hot mix asphalt (HMA) variability. A questionnaire was written to gather general information about the QC/QA specification programs that are being used in the United States... Fluctuation in temperatures significantly affects pavement stability and the selection of asphalt grading to be used in pavements. Ability to accurately predict the asphalt pavement temperature at different depths and horizontal locations based on ambient air temperatures will greatly help pavement engineers... State Highway Agencies (SHAs) in the United States use smoothness specifications to insure that they are providing the public with quality roads. Monetary incentives / disincentive policies based on the initial roughness values are used by SHAs to encourage contractors to build smoother roads. To justify... This project used field and laboratory evaluations to study the possibility of incorporating bottom ash in asphalt mixes. A pavement test section was constructed for the field portion of the project. The laboratory evaluations involved design and accelerated testing of control and bottom ash asphalt... This report examines the feasibility of using the thermal stress restrained specimen test to evaluate low temperature cracking in asphalt pavement mixes. Data were collected from laboratory and field evaluations. Various mixing, aging, and compaction methods were used to prepare test samples with materials... The feasibility of using the Georgia Loaded-Wheel Tester (GLWT) to predict rutting in the laboratory was investigated in this research. This research was performed in two phases. The first phase consisted of modifying the GLWT to handle 15.2 cm (6 in) cores, developing a laboratory compaction procedure...
|