|
|
MPC Research Reports
Filter by Keyword8 report(s) found with failure in the keywords field 1 - 8 of 8 This study evaluates a comprehensive experimental investigation to better understand the mechanical and deformation behavior of Wyoming bedrocks and therefore to improve the design and construction of transportation infrastructure. Fifty-six rock samples were collected from different locations around... This report presents a comparative experimental study on the axial behavior of concrete subjected to alkali-silica reaction (ASR) with and without confinement by carbon-fiber reinforced polymer (CFRP) sheets. A total of 120 cylinders are cast using two types of coarse aggregates to represent variable... On September 11-17, 2013, Colorado suffered devastating and widespread flash flooding over 150 miles from Colorado Springs north to Fort Collins, impacting 24 counties. The flood damaged several bridges and over 400 miles of state roads. As a result of the transportation damage, residents of Drake, Colorado... Calcium sulfoaluminate (CSA) cement was used to cast a prestressed voided deck slab bridge girder. The rapid-set properties of CSA cement allowed the initial concrete strength to reach the required 4300 psi needed in order to cut the prestressing strands 6.5 hours after casting. Prestress losses were... This study evaluates the seismic performance of circular concrete-filled tube (CCFT) columns in accelerated bridge construction (ABC) projects. CCFT components are considered of interest for bridges subjected to seismic forces due to their efficient structural behavior under combined axial and bending... Compared with conventional lap splicing, mechanical splicing is an alternative method of connecting bars in reinforced concrete (RC) structures, and is used mainly to reduce bar congestion in joints. Recently, mechanical bar splices, which are also referred to as bar couplers, have been used in laboratories... This report presents a two-phase research program studying i) galvanic current influencing deterioration of carbon fiber reinforced polymer (CFRP) sheets bonded to a steel substrate and ii) electrochemical reaction for steel beams strengthened with CFRP. The first phase of the research presents an experimental... This report describes research performed in coordination with work at the University of Stuttgart, attempting to establish the S-N curve for fatigue loading of notched wood-concrete connections based on low/high-cycle, repeated loading tests. Experimental results are obtained on fourteen 1524 mm span... |
